Paper CraftsCuttlebug Machine, Embossing Folders, Metal Dies, Sandwich Plates

Provo Craft Cuttlebug Embossing Workflow

This workflow provides step-by-step guidance for provo craft cuttlebug embossing workflow.

Physical diesEmbossing folders

Key Tips

  • What is the difference between embossing and debossing? Embossing raises the design (convex). Debossing presses it inward (concave). Cuttlebug does both—flip the die over for debossing, or use embossing folders for raised texture.
  • Can I emboss metal with Cuttlebug? Yes, thin copper and aluminum foil (20-26 gauge). Use lower pressure settings, feed slowly, and check alignment. Thicker metal requires a separate metal embossing press.

Common Questions

Refer to the FAQs below for answers to frequently asked questions.

Frequently Asked Questions

What is the difference between embossing and debossing?

Embossing raises the design (convex). Debossing presses it inward (concave). Cuttlebug does both—flip the die over for debossing, or use embossing folders for raised texture.

Can I emboss metal with Cuttlebug?

Yes, thin copper and aluminum foil (20-26 gauge). Use lower pressure settings, feed slowly, and check alignment. Thicker metal requires a separate metal embossing press.

Why is my embossing uneven or faint?

Sandwich plates misaligned, die worn out, or feed speed too fast. Check plate alignment, replace worn dies, and slow feed speed. Run through twice at lower pressure for thick cardstock.

Can I reuse dies I've already purchased for Cricut?

No. Cricut and Cuttlebug use different die systems. Cricut dies are cartridges; Cuttlebug uses metal dies with different edge shapes and thicknesses.

How do I prevent cardstock from sticking to the die?

Apply release spray or dry cooking spray to die before use. Let spray dry (1-2 minutes), wipe off excess with paper towel, then load cardstock.

Ready to convert your files?

Upload your images and start creating with Cuttlebug Machine.

Convert Now